Test-Ok eC-test-mate, Hardware Reference Manual

Page: 14 / 35

Copyright © TEST-OK. All Rights Reserved.
14 / 35
`
Board Presence
A test pin with internal pull-up is available in order to detect whether the eC-test-mate is connected to the
PCB under test or not. Connect the corresponding test pad on the PCB under test to GND. The pin is called
BOARD_DETECT.
Note: it is mandatory that the Board Detect pin of every eC-test-mate that is used in a test is connected to
GND on the UUT when using the TEST-TRACK or eC-my-test software, since a test cannot be started when
no board under test is detected. The board presence is used to determine whether a test can be started. If
there is no board present, no test can be started.
Associated test commands:
• DISABLE_BOARDDETECT
• ENABLE_BOARDDETECT