Test Equipment Depot gom-802, User Manual

Page: 5 / 55

SAFETY INSTRUCTIONS
5
Safety Guidelines
General Guideline
CAUTION

Do not place any heavy objects on the GOM-802.

Avoid severe impact or rough handling that leads to
damaging the GOM-802.

Do not discharge static electricity to the GOM-802.

Use only mating connectors, not bare wires, for the
terminals.

Do not disassemble the GOM-802 unless you are
qualified as service personnel.
(Note) EN 61010-1:2001 specifies the measurement categories and
their requirements as follows. The GOM-802 falls under category
I.

Measurement category IV is for measurement performed at the source
of low-voltage installation.

Measurement category III is for measurement performed in the
building installation.

Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.

Measurement category I is for measurements performed on circuits
not directly connected to Mains.
Power Supply
WARNING

AC Input voltage: 100V/ 120V/ 220V/230 V AC,
50/60Hz, 27VA, 22W

The power supply voltage should not fluctuate more
than 10%.

Connect the protective grounding conductor of the AC
power cord to an earth ground, to avoid electrical
shock.
Fuse
WARNING

Fuse type:
Line Voltage Rating Fuse
100V 90-110V T0.3A 250V
120V 108-132V T0.3A 250V
220V 198-242V T0.25A 250V
230V 216-250V T0.25A 250V

Make sure the correct type of fuse is installed before
power up.

To avoid fire, only replace the fuse with the specified
type and rating.

Disconnect the power cord before fuse replacement.

Make sure the cause of a fuse blowout is fixed before
fuse replacement.