Tiger Shark Operation Instruction Manual
http://tesoro.com/TigerShark_Manual.htm
5 sur 15
21/06/2007 14:32
ADJUSTMENT
The searchcoil angle and stem length should be adjusted so that the unit
does not become uncomfortable or tiring to hold after long periods of use.
The detector should rest in your hand with arm relaxed allowing it to
swing back and forth without having to lift with the elbow or shoulder
while keeping the searchcoil as close as possible to the ground without
touching. The pole length is adjusted by depressing the spring buttons and
extending or shortening the lower stem until they click into the set of
holes that give you the most comfortable setting. The searchcoil should
rest about one inch above the ground while standing erect. Adjust the
angle of the searchcoil so that it is parallel to the ground. Tighten the
searchcoil thumbnut by hand so that the searchcoil will maintain this
setting.
QUICKSTART TEST AND TUNING PROCEDURES
The Quickstart is designed to teach you how to use your new Tiger Shark. It provides a quick and easy
means of learning your detector and the concepts behind all of the functions.
Important Note:
The Tiger Shark has two very different modes of operation. Normal is used for dry land hunting or fresh
water hunting. Salt Mode is for wet salt sand and salt water hunting only. The modes cannot be
interchanged. When you switch modes, you are actually changing the internal setup of your Tiger Shark.
Please be very aware what mode your detector is in while you are hunting.
The controls for the two separate modes on your Tiger Shark operate almost exactly the same. As you
follow the Quickstart, it will be assumed that you are operating in the Normal Mode. Any differences
between the Normal and Salt Modes will be noted. You may want to go through the Quickstart in Normal
Mode first and then repeat it using the Salt Mode.
You will need the following items:
Your fully assembled Tiger Shark Detector.
1.
An iron target (a small nail or screw will do), a nickel, a pull tab and a quarter.
2.
A fine jeweler's screwdriver.
3.
A nonmetal table or counter surface.
4.
Here's what you will do:
Perform Audio Battery Test.
1.
Set Ground Adjust.
2.
Perform Air Test in ALL MET Mode.
3.
Check and Set the Internal Controls.
4.
Perform Air Test in MOTION DISC Mode.
5.
Prepare for the Quickstart
Place your assembled Tiger Shark on the nonmetal surface as shown in the photo below. Make sure there
are no metal objects near the coil and remove any jewelry from your hands and wrists.
