29
ENG
NOTE
EN 50242
: This program is the test cycle. The information for comparability test in accordance
with EN 50242.
Starting A Cycle Wash
Changing The Program Mid-cycle
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the
lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page ”Product fiche”. Make sure that the water
supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the dishwasher will start
its cycle.
A wash cycle can only be changed if it has been running for a short time otherwise, the detergent may have
already been released and the dishwasher may have already drained the wash water. If this is the case, the
dishwasher needs to be reset and the detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button for more than 3 seconds - the program will cancel.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds, the dishwasher will start.
Means: need to fill rinse into the Rinse-Aid Dispenser.
Program
Description
Of Cycle
Detergent
Pre/Main
Running
Time(min)
Energy
(Kwh)
Water
(L)
Rinse
Aid
90 Min
Wash(65°C)
Rinse
Rinse(65°C)
Drying
5/25g
–––––––––––––
(1 piece)
90
1.35
12.5
Rapid
Wash(45°C)
Rinse(50°C)
Rinse(55°C)
20g
30
0.75
11
3 sec
