4/6
5
Operating Instruction
Switching on:
Remove screws and housing and insert battery (see figure below, red arrow indicates positive pole, blue
arrow indicates negative pole). Inserted battery switches actuator on. Reinstall housing and screw in the
screws. Reverse the procedure to switch the device off or to replace the battery.
When installing antenna, hold antenna by knurled end.
Configuration:
Setting and configuration of the Actuator and whole measuring system is realized by Central Unit
connected to PC and TERAview application.
Central Unit is not included with package of TAR2 and it is sold
and delivered extra; see
http://www.tesla.cz/en/tera-centrala/
.
TERAview application, drivers and user manual with detail configuration description is free downloaded
on website:
http://www.tesla.cz/en/ke-stazeni/
.
For successful actuator configuration in measuring system it is essential to know actuator radio channel
number (communication wireless channel) and P2P address (identification in wireless net). Both parameters
are printed out on actuator serial number plate. Actuator radio channel number is possible to change by
TERAview application and it must be identical to central unit radio channel number. P2P address is
permanent and it can occur in one big wireless net only once. Central Unit P2P address can be identical to
P2P address of other elements in network.
6
Basic Maintenance
Battery replacement:
Current battery charge status of Actuator can be monitored wirelessly by Central Unit (see ´Operating
instruction/Configuration´). In case of low battery capacity Central Unit displays warning message. To
replace discharged battery follow ´Operating Instructions / Switching on´ paragraphs. Replace it with
appropriate type of battery (see ´Product Specification´). Batteries can be ordered from TESLA
manufacturer or distributor (see ´Accessories´).
7
Safety
Installation, connection and operation may only be carried out by a specialist with relevant qualification
who is perfectly familiarized with this manual and device function.
Always ensure that there is no power in a connected device before proceeding with installation.
8
Electrical Connection
Output relay can switch power load up to 30W (1A/30V) or it is possible to connect directly TPS2 power
relay 1500 VA (6A/250V) from TERA program; see
http://www.tesla.cz/en/tera-rele/
.
Attention! Switching relay of actuator is not designed for switching mains 230V / 50Hz!
