5
ENG
UNPACKING YOUR FREEZER
SPACE REQUIREMENTS
ELECTRICAL REQUIREMENT
CLEANING BEFORE USE
WARNING: Use two or more people to move Freezer.
Failure to do so can result in back or other injury.
• Remove tape and any labels from your Freezer before using(except the rating label).
• To remove any remaining tape or glue, rub the area briskly with your thumb.
• Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your Freezer.
• When moving the Freezer, do not tilt the Freezer beyond 45°from upright position.
WARNING: Keep flammable materials and vapors, such as gasoline, away form Freezer.
Failure to do so can result in death, explosion, fine or burns.
• To ensure proper ventilation for your Freezer, allow for 200mm space on each side between walls,
200mm space between back of your Freezer and the wall, and 300mm space between counter top and
the roof or ceiling.
• If you are installing your Freezer next to a fixed wall, leave sufficient space on the hinge side to allow for
the door to swing open.
• Never install your Freezer near heat source and direct sun shins.
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your Freezer into its final location, it is important to make sure you have the proper
electrical connection.
Recommended Earthing Method
A 220~240 Volt /50 Hz AC only 10 ampere fused and properly earthed electrical supply is required. It is
recommended that a separate circuit serving only this appliance be provided. Use a receptacle which
cannot be turned off with a switch or pull chain. Do not use an extension cord.
NOTE
Before performing any type of installation, disconnect the Freezer from the electrical source. When you are
finished, connect the Freezer to the electrical source and reset the control to the desired setting.
After you remove all of the packaging materials, (especially the foam between outside condenser and
cabinet should be removed) clean the inside of your Freezer before using it.
Summary of Contents for RU0900M
