WET MOPPING
After dust cleaning, the dirt container can be replaced by the water tank. For best results, we
recommend using this feature in one room and then moving with wet mopping to the next room.
Install the blue mopping fabric on the bottom with the
water tank. Lightly dampen the mopping fabric for a
faster and smoother wiping. When removing the mop
from the holder, make sure you do not damage the velcro
fastener on the bracket quickly.
If the mop is dirty after cleaning, you can clean it with
lukewarm water.
Open the plastic cap and take the water into the plastic
water tank.
Put the water into the water softener only after
removing the container from the vacuum cleaner.
Handling of the water wipe can cause a slight leakage
of residual water, for example. In this case, wipe the
polished place immediately with a dry cloth.
We recommend that the floor be wiped with clean
water, the detergent may cause foam to soften water
dripping on the mop, or cause smudges on the floor
after drying.
Remove the dust tank from the unit and insert the
water tank.
Do not spill water into the vacuum cleaner or its inner
part, the vacuum cleaner is not waterproof.
Press the "
AUTO
" button on the vacuum cleaner or "
7
" on the remote control to start wiping with
water. In this mode, vacuuming is switched off, only side cleaning brushes work´and main brush.
The water drips automatically, so do not let the vacuum cleaner stand in a place without movement
or with any residual water in the water tank to prevent spillage of water on the floor.
Do not use wet mopping on the carpet.
Keep enough water in the water tank for water mopping.
Remove the water tank after cleaning has finished.
Do not charge the battery with the water tank for safety reasons.
Summary of Contents for RoboStar T60
Page 1: ...TESLA RoboStar T60...
Page 69: ......
