Tesla RD2400M1, User Manual

Page: 7 / 52

7
ENG
OPERATION
Switching On Your Unit
• The temperature selector knob is located on the right hand
side wall of the refrigerator interior wall of the refrigerator
interior Setting“Off”: UnitOff Setting“Min”: Less Cool
Temperature
• Setting“Med”: Normal Operation(adequate for most
situations) Setting“Max”: Coolest Temperature
• During high ambient temperatures e.g. on hot summer
days. It may be necessary to set the thermostat to the
Coolest setting(position“Max”).This may cause the
compressor running continuously in order to maintain a low
temperature in the cabinet.
• For the first time you install your refrigerator, set the
thermostat knob at “Med”.
• Give your refrigerator time to cool down completely before
adding food. It is the best to wait 24 hours before adding
food. The thermostat knob controls the temperature. When
the thermostat control knob is set to OFF, the refrigerator
will not be running.
Noise Inside the Unit!
You may notice that your unit makes some unusual noises.
Most of these are perfectly normal, but you should be aware
of them!
These noises are caused by the circulation of the refrigerant
liquid in the cooling system. It has become more pronounced
since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your unit. This is the
compressor motor working, as it pumps the refrigerant
around the system.
Tips for Keeping Food in the Unit
• Cooked meats/fishes should always be stored on a shelf
above raw meats/fishes to avoid bacterial transfer. Keep
raw meats/fishes in a container which is large enough to
collect juices and cover it properly. Place the container on
the lowest shelf.
• Leave space around your food, to allow air to circulate
inside the unit. Ensure all parts of the unit are kept cool.
• To prevent transfer of favours and drying out, pack or cover
the food separately. Fruit and vegetables do not need to be
wrapped.
• Always let pre-cooked food cool down before you put in
the unit. This will help to maintain the internal temperature
of the unit.
• To prevent cold air escaping from the unit, try to limit the
number of times you open the door. We recommend that
you only open the door when you need to put food in or
take food out.
Change the Light Bulb
Lamp replacement by professionals
CLEANING
Defrosting
Auto-defrost for Frost-free Refrigerator
Cleaning the Interior and the Exterior of
the Unit
• Dusts behind the refrigerator and on the ground shall be
timely cleaned to improve the cooling effect and energy
saving.
• Check the door gasket regularly to make sure there are no
debris. Clean the door gasket with a soft cloth dampened
with soapy water or diluted detergent.
• The interior of the refrigerator should be cleaned regularly
to avoid odor.
• Please turn off the power before cleaning interior, remove
all foods, drinks ,shelves, drawers, etc.
• Use a soft cloth or sponge to clean the inside of the
refrigerator, with two tablespoons of baking soda and a
quart of warm water. Then rinse with water and wipe clean.
After cleaning, open the door and let it dry naturally before
turning on the power.
• For areas that are difficult to clean in the refrigerator (such
as narrow sandwiches, gaps or corners), it is recommended
to wipe them regularly with a soft rag, soft brush, etc. and
when necessary, combined with some auxiliary tools (such
as thin sticks) to ensure no contaminants or bacterials
accumulation in these areas.
• Do not use soap, detergent, scrub powder, spray cleaner,
etc., as these may cause odors in the interior of the
refrigerator or contaminated food.
• Clean the bottle frame, shelves and drawers with a soft cloth
dampened with soapy water or diluted detergent. Dry with
a soft cloth or dry naturally.
• Wipe the outer surface of the refrigerator with a soft cloth
dampened with soapy water, detergent, etc., and then wipe
dry.
• Do not use hard brushes, clean steel balls, wire brushes,
abrasives(such as toothpastes), organic solvents (such as
alcohol, acetone, banana oil, etc.), boiling water, acid or
alkaline items, which may damage the fridge surface and
interior. Boiling water and organic solvents such as benzene
may deform or damage plastic parts.
• Do not rinse directly with water or other liquids during
cleaning to avoid short circuits or affect electrical insulation
after immersion.
Cleaning Tips
Condensation may appear on the outside of the unit. This
may be due to a change in room temperature. Wipe of any
moisture residue. If the problem continues, please contact a
qualified technician for assistance.