3
KNOW ELECTRIC KETTLE
BEFORE USING KETTLE
USING YOUR ELECTRIC KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your kettle before use by boiling
the Max capacity of water once and then discarding the water twice. Wipe the surface with a damp cloth.
NOTE
: The max capacity of kettle is 1.7L.
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and
open the lid by pressing down lid release button,
then fill the kettle with the desired amount of water
and close the lid. The water level must be within the
Min and the Max level. Too little water will cause the
kettle switching off before the water has boiled.
NOTE
: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before
plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down
the switch and the indicator will light up, and then
the kettle starts to boil the water. The kettle will
switch off automatically once the water has boiled.
If necessary, it will take you 30 seconds to wait
before pressing the switch again to re-boil the
water. You may shut off the power by lifting switch
up or directly lift the kettle from the power base at
any moment to stop boiling process.
NOTE
: Ensure that switch is free of obstructions
and the lid is firmly closed, the kettle will not turn
off if the switch if be constrained or if the lid is
opening.
5. Lift the kettle from the power base and then pour
the water.
NOTE
: Operate carefully when pouring the water
from your kettle as boiling water may result in scald,
besides, don’t open the lid while the water in the
kettle is hot.
6. The kettle will not re-boil until the switch is pressed
again. The kettle may be stored on the power base
when not in use.
NOTE
: Always disconnect the power supply when
not use.
Lid asm
Lid button
Handle asm
Switch
Power cord asm
Body
Water gauge
Body Decorative
ring
Base
