Tesla IR400GP, User Manual

Page: 6 / 44

6
Simple Repair Methods
Problem Possible Reasons Measurement
Not enough heat or Too heat
Rotate thermostat dial improperly or
unplugging
Correct Thermostat dial in position and
check if the iron is plugged.
No steam or Leakage The thermostat dial has been set to MIN
Set the thermostat dial to the required
positioin.
No burst of steam or no
vertical steam
The (vertical) burst of steam function has
been used too often within a very short
period. The iron is not hot enough
Continue ironing in horizontal position and
wait a while before using the (vertical) burst
of steam function again
Leaking water from Soleplate
Set the thermostat dial out of steam range. Set the thermostat dial as per steam range.
The heat is still not enough.
Open steam button only after the indicator
light goes off.
The water is over than max position Pour out the remaining water
Little Steam
Check if the steam selector is in proper
location.
Set the steam selector to the proper
location.
Steam hole is blocked. Clean hole with distilled water.
Too little water in the water tank Fill water into the box
No Spraying No enough pressure or air inside
Press the spray nozzle by hand, and push
the spray button several times continuously.
TECHNICAL SPECIFICATION
Voltage: AC 220V - 240V~
Frequency: 50Hz-60Hz
Power: 3100W
Correct Disposal of this product:
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased, they can take this product for environmental safe
recycling