TESI XE18PB06, Instructions For Use And Maintenance Manual

Page: 52 / 66

PORTABLE HIGH-ENERGY IGNITER
– XE18PB06 - Rev.00
51
7.6 CORRECTIVE MAINTENANCE
DANGER
Before acting on any mechanical or electrical component, the Maintenance Manager will
have to disconnect the battery until servicing is completed and only then can restore
normal operating conditions to verify the ignition device.
This is to prevent someone from re-enable the ignition device without alerting those who
are performing maintenance.
Apply also on the ignition device a sign indicating that the same is maintained.
The Maintenance Manager is the main responsible for any accidents that may occur
during these operations, therefore it is strongly recommended to perform the procedure
described above in order to avoid serious and unpleasant trouble.
DANGER
Before connecting an electrical component, carefully study the electrical circuit, a bad
connection can cause injury or damage.
This may be done only by qualified personnel.
In this section describes the corrective maintenance operated by a qualified technical personnel to carry out
repairs on the ignition device.
The Table 7.2 lists the corrective maintenance activities.
Table 7.2
– Corrective maintenance
NR.
PR. DESCRIPTION REFERENCE
SECTION
1 Replacing the electronic board 7.6.1.6.1
2 Replacing the battery 7.6.2
3 Replacing the capacitor 7.6.3
4 Replacing of the spark gap 7.6.4
Spark tip
Copper washer
Ignition lance
Inner slot