33
4
1
Remove the cap.
2
Press and hold down the Power switch.
A short beep [pit] sounds, and the indicator lamp "LOW" flashes.
The roller ball warms up to a temperature suitable for use in about 2 min after pressing the Power switch.
The level indicator lamp turns from flashing to the continuously on mode.
●
See "Using the Appliance with alternating current system" (page 6).
3
Set the microcurrent level using the Level
Changeover switch.
Preset to "LOW" as the mode that immediately
follows the startup.
Only the indicator lamp associated with the selected level flashes or
lights up.
●
At the beginning of use, you are recommended to set the level to
"LOW" to use the appliance for a short period of time.
●
Stop using the appliance if you start to experience any discomfort.
4
Grasp the body so that your hand touches the
earth plate.
Be sure to keep your hand in contact with the left or right earth plate
when grasping the body. You cannot obtain the desired effect if your
hand is not kept in contact with either earth plate of the body.
The appliance should be used within 3 min for each session, and up to twice a day.
When 7 min have passed after pressing the Power switch, the power is turned off automatically.
Level Changeover
switch
Earth plate
The appliance must not be used for any region other than the area
under each eye (from the inner corner to outer corner of the eye).
(Failure to follow these instructions may result in accident or injury.)
Remove your contact lenses before using the appliance.
(Failure to follow these instructions may result in eye problems.)
WARNING
How to Use