VCU10P Vacuum Cleaner User Guide
Debris Screen
Cleaning the Dust Cup Filters
Empty the Dust
Open the base of the cup over a
bin.
Shake out as much dust as
possible.
HEPA Filter
Hold the dust cup firmly with one hand. Place your other hand
inside the cup and take hold of the debris screen tube.
Rotate the cup lid to
the right to the
Rotate the debris screen firmly to the right to unlock it and then
UNLOCK position
carefully withdraw the screen from the tube.
and lift the lid off.
Rotate the
filter to the
left to unlock
the filter from
the cup lid.
Remove the
filter.
Rinse the debris screen under the tap in lukewarm water to
remove any dust. The dust cup and dust cup cover can also be
washed in lukewarm water.
Do not use strong detergents. DO
NOT place any part in a
dishwasher.
Allow all parts to fully dry.
To replace the screen:
Thread the screen over the
vanes in the black inner
tube. Align the three lugs
with the slots in the cup and
turn fully anticlockwise to
lock firmly.
Replace the dust cup cover
on the dust cup and replace the assembled dust cup in the
At least once a month or when you notice a decrease in
vacuum cleaner.
suction, wash the HEPA filter by running it under the tap. Run
the water on the dirty side until it runs clear. After washing allow
the HEPA Filter to fully air dry. (This may take up to 24 hours.)
Only when the filter is dry should you replace it in the Dust Cup.
The HEPA filter should be replaced at least every six months
(and ideally three)
to keep your cleaner in peak condition.
Page 8
Hold the HEPA filter
over a bin.
Tap the hard plastic
underside of the filter
on the edge of a bin to
shake off any excess
dust. Use the supplied
cleaning brush to
remove all traces of
dust and debris from
the pleats of the filter.
UNLOCK
LOCK
LOCK
UNLOCK
LOCK
UNLOCK