5
Operation
Fitting/removing the jug
Preparing the blender
NOTE: The maximum operating time is two
minutes. If you exceed this time you must rest the
unit for five minutes.
For best results, the food ingredients should
include some liquid content. This may be water,
fruit juice, milk etc depending on the recipe.
• Check that the power cord is disconnected and
that the Power/speed control is set to the ‘0’
(Off) position.
• The lid is a push fit in the top of the jug.
Remove the lid and place the ingredients in the
jug. Add any liquid ingredients first, then any
solid ingredients.
Hold back some of the liquid initially. It is better to
add more liquid during blending if required.
• Fit the lid to the jug.
• Fit the cap and lock it in place.
• Fit the jug to the motor body and lock it in
place.
• Connect the power cable to a mains outlet.
Blending continuously
• To blend continuously, turn the Power/speed
control to the 1 position (slow), 2 (medium) or
3 (fast).
The blender will switch on. If you are not sure which
speed setting to use, start with the slow speed and
increase the speed to high if needed. High speeds are
best if the ingredients are quite solid.
• Watch blending progress through the jug and
turn the Power/speed control to the ‘0’ (Off)
position when you have finished blending.
Pulse blending
Pulse blending is useful for short bursts of
powerful blending.
• Turn the Power/speed control to the ‘Pulse’
position.
• The motor will run while the speed control is
held in this position.
• Release the Power/speed control to stop
blending at any time.
You can turn the Power/speed control repeatedly to
the ‘Pulse’ position to blend in pulses, allowing the
ingredients to settle if required.
The jug locks to
the motor body.
Always ensure the
jug is locked in place
before switching on
the blender.
Refer to the
drawings of the jug
and motor body.
To fit the jug, place the jug on the motor body
aligning the arrow on the jug with the unlock
symbol. Twist the jug until the pointer on the jug
lines up with the lock symbol on the motor body
as shown.
• To remove the jug, twist the jug to line up the
pointer on the jug with the unlock symbol on
the motor body. Lift the jug off the motor body.
Fitting/removing the cap in the lid
The cap locks to the lid. Always lock the cap to the
lid before use.
Lock
Unlock
Rotate the cap
as shown to
lock or unlock it
when fitting or
removing it.
Lock
Unlock
