PF1614W/B
EN
4
H
Fit the Rear Guard on the motor housing and align the
guard plate over the mounting lugs.
Replace the guard nut and hand tighten it firmly.
Discard the plastic sleeve on the motor shaft.
Attached to the rear fan guard there are two small screw
and nuts. Remove them and keep them safe.
The front guard has five hinged clips and one fixed clip
which is located at the top of the guard. Open the hinged
clips.
Line up the front and rear guards and slide the front
guard over the rear guard hanging it by the fixed clip.
There are two small fixing holes in each guard. Line them
up, and loosely fix a screw and nut into each hole.
Slide the other clips into position to attach the two
guards.
Now tighten the fixing screws.
The fan is now fully assembled.
I
Fit the fan blade onto the motor shaft.
There is a flat machined on the motor spindle – align the
fan blade so that it fits the spindle correctly.
Push the fan blade fully home.
Unscrew the guard nut from the motor by rotating it
anticlockwise.
Unscrew the spinner from the motor by rotating it
clockwise.
J
Screw the spinner anticlockwise to the threaded end of
the motor shaft. Tighten firmly.
Tight
Loose
Top clip
