PF1614W/B
EN
3
ASSEMBLING YOUR FAN
A
Identify the feet
as shown in the
illustration
C
Line the base of the
pole over the screw
holes in the base.
Screw the base of
the pole firmly into
the feet with the four
screws.
B
Place the feet on a firm
surface with the lower slot in
Foot 1 over the upper slot in
Foot 2.
Remove the four screws and
save them.
D
Unscrew and remove the
pole clamp. The pole will
stay in position with the
pressure of the internal
collet.
If the pole drops down,
invert the stand and the
pole will re-appear!
E
Drop the decorative
cover over the poles
and place it over the
feet as shown.
Replace the pole
clamp.
F
Pull the inner column up so
that about 150mm protrudes
through the top of the lower
pole.
Tighten the pole clamp
securely.
Pull on the inner column to
make sure it is securely fixed
and cannot be pulled clear of
the base.
G
Loosen the screw at the
bottom rear of the switch
housing.
Lower the switch housing
onto the inner column.
Make sure it is well seated.
Tighten the screw firmly.
CAUTION: Do NOT loosen
the Pole Clamp at any time
during this operation as
this might result in personal
injury or damage to the
appliance.
