PET 1 Vacuum Cleaner User Guide
Cleaning the Dust Cup Filters
HEPA Filter
Debris Screen
Remove the cup. Hold the cup as
shown. Rotate the cup lid to the
right to the UNLOCK position and
lift the lid off.
Hold the cup over a bin. In the cup
lid there is a spinner.
Rotate the spinner in both
directions to shake all the dust
off and thoroughly clean the
pleats of the filter.
At least once a month or if you
notice a decrease in suction,
remove and clean the filter.
To remove the filter:
Hold the filter as
shown. Keep the cup
still and rotate the
filter to the left to
loosen it. Now lift it
out.
After removing the
filter, tap the plastic
underside on the
edge of a bin to
remove loose dust.
Now brush the filter
out with a soft brush
and rinse it under the tap. Run the water on the dirty side until it
runs clear. After washing allow the HEPA Filter to fully air dry.
Only when the filter is dry
should you replace it in the Dust Cup.
To replace the filter, ensure
the rubber seal is in place
around the top edge of the
filter cage. Thread the filter
over the arms of the pleat
spinner and. Insert it fully
into the cup lid and twist
clockwise to lock it in place.
The HEPA filter should be replaced at least every six months
to keep your cleaner in peak condition.
Open the dust cup. Hold the dust cup firmly with one hand.
Place your other hand inside the cup and take hold of the
debris screen tube.
Rotate the debris screen firmly to the right to unlock it and then
carefully withdraw the screen from the tube.
Rinse the debris screen under the tap in lukewarm water to
remove any dust. The dust cup and dust cup cover can be
washed in lukewarm water.
After removing the filters he dust cup may now be washed out
in warm water and allowed to dry.
Do not use strong detergents. DO
Thread the screen over the vanes in the black inner tube. Align
the three lugs with the slots in the cup and turn fully
anticlockwise to lock firmly.
Replace the dust cup cover on the dust cup and replace the
assembled dust cup in the vacuum cleaner.
(There may be
some resistance from
the springy arms of
the spinner.)
(This may take up to 24 hours.)
(and ideally three)
NOT place any part in a
dishwasher. Allow all parts to fully dry.
To replace the screen:
Page 8
UNLOCK
LOCK
UNLOCK
LOCK
