SEWING ON BUTTONS
Set the Stitch Length Dial and the Pattern Selector as shown
Install the Button Sewing Foot
Install the Darning Plate. ( See Fig 1)
Position the work under the foot.
Place the button on the marked position and lower the foot. Set the pattern
selector knob on “B” and sew a few securing stitches.
Select the zig-zag stitch width according to the distance between the two holes of
the button.
Turn the handwheel to check if the needle goes into the right and the left hole
of the button without any obstruction (adjust the stitch width according to the
button).
Slowly sew on the button with about 10 stitches.
Select pattern “B” and sew a few securing stitches.
If a shank is required, place a darning needle on top of the button and sew. (Fig. 3)
For buttons with 4 holes, sew through the front two holes first ( Fig. 2), push the
work forward and then sew through the back two holes as described. (Fig. 3)
STITCH LENGTH DIAL
DARNING PLATE
Page 22
