7
7.When plugged in, turn on switch, the LED light will come on. Turn the adjustable knob
to MAX position, wait about 15 seconds until you see steam coming out, your mop is
ready to use, slowly turn the knob to adjust the steam flow rate depending on the type
of floor to be cleaned. 8.Slowly move the steam cleaner back and forth across surface
to be cleaned, it is rec-
ommended to sweep or vacuum floor prior to using the steam mop.
9.When the steam mop stops emitting steam, after approximately 20 minutes of use, turn
off the steam mop and refill the water tank, turn on and continue cleaning.
10. When you have finished cleaning, unplug power cord from outlet, allow the cleaner to
cool, empty the water tank, carefully remove the cloth pad from the head, wrap cord
and store it upright in a dry area or hang on a storage hook.
NOTE
: Do not plug another appliance on the same circuit to avoid circuit overload.
CAUTION
: To sanitize a certain area of your floor, leave the steam mop over that area
for a minimum of 5 seconds, but no longer than 15 seconds, leaving the steam mop in
a stationary position for a longer period than recommended may cause the build-up of a
pale residue, this residue can be removed by using a decalcifying product or a few drops
of vinegar.
WARNING
: NEVER run the steam mop without water. Never direct steam at any person
or animal. Use the steam mop on sealed hardwood floors only.
CAUTION
: The cloth pad may be very hot, let mop cool down before touching.
Note: When removing and mounting the head, make sure you always unplug the power
outlet. Please do not remove and replace the head immediately after using, the head is
very hot, it will cause burns, possibly severe. Allow the body parts enough time to cool
down before disassembling and replacing.
CAUTION:
Prior to cleaning or maintenance unplug cord from the power outlet.
Do not immerse the unit in water.
1. Disassemble the mop head. Attach Garment Steaming attachment to body, make sure
it snaps in correct position. (Fig. D No.1 and No.2)
2. Insert window cleaning head into the garment steaming attachment, make sure to
insert in correct position – insertion slot. (Fig. D-No 3)
3. Push the window cleaning head to clamp step. Make sure it snaps in position. (Fig. D
No. 2 and No.3)
4. Check and ensure the window cleaning head is locked properly. (Fig. D No. 4)
1.Cleaning pad can be machine washed in hot water and tumbled dry.
2.Wipe the steamer with a soft cloth.
Window Cleaning Attachment
CLEANING AND MAINTENANCE
Removing and replacing the head
To purchase spare cleaning pads contact [email protected] or 0844 8000031
