Installing the drivers in Windows XP (Service Pack 1)
If you have not already done so, place the enclosed installation CD into your CD-ROM drive.
A. Windows XP will recognize the new device and will launch the hardware installation wiz-
ard. Next, select “Install the software automatically [Recommended]” and click “Next”.
B. Windows XP will automatically find the correct driver on the installation CD.
C. In the following dialog box, Windows XP will inform you that the driver did not pass the
“Windows Logo test”. Click “Continue”.
D. Conclude the installation by clicking “Finish”.
This completes the installation of the drivers and you can now start installing the application
programs.
Connecting the magnetic-base rod antenna
Connect the antenna plug of the included magnetic-base rod antenna to the antenna input (B)
of the Cinergy T².
Antenna location.
Avoid setting the antenna up near sources of electromagnetic radiation.
These include computers, TVs, microwave ovens and similar devices. Avoid the proximity of
steel or reinforcing rods. Set the antenna up close to a window, positioning it as high as
possible.
Remote control – inserting the batteries.
Improper battery use can destroy the remote control unit. Please observe the following in-
structions:
·
Never mix old and new batteries.
·
Insert the batteries as indicated by the polarity markings in the battery compartment.
Please observe your local laws and environmental regulations when disposing of used batter-
ies.
12
Cinergy T² Hardware (English)