A
P P E N D I X
C
C
HAPTER
0
ASCII C
OMMAND
/R
ESPONSE
S
TRUCTURE
Cyber Hardened IBUC Console and SSHv2 Command Set
This command set is used with RS232 and SSHv2 interfaces.
• Parameters are delimited by “< >” for clarity and are not part of the actual query or
command. Single quotes delimit an exact string used for a parameter.
• It is expected that both commands and responses are terminated by using
<LF><CR>, where
<LF> = 0x0A. (Line Feed)
<CR>= 0x0D. (Carriage Return)
Be sure to configure the SSHv2 or RS232 client accordingly.
In some cases users may type queries/commands with structures that differ from what
is expected. In this case one should receive an “Error Response” from the IBUC unit.
In such cases, refer to
for a more detailed explanation about such errors.
Table C.1
Error Response Table
Code
Error Message
Description
1
error = invalid value
This is not a valid value for this command.
2
error = bad command
This command is not in the command set.
3
error = func not yet done
This command has not been implemented.
4
error = bad format in command
One of the parameters is formatted
incorrectly.
5
error = error accessing config storage
Unable to access EEPROM.
6
error = ODU fault
Cannot switch, target unit has a major fault.
7
error = Please enter valid password
Incorrect password has been entered.
8
error = Switch Fault
The waveguide switch is faulted.
9
error = ODU Comm Fault
Legacy Binary packet checksum is invalid.
Summary of Contents for IBUC 2
