Installation and Operating Guide
Smart
® Desiccator
Copyright 2017 Terra Universal Inc. All rights reserved. • Revised August 2020 • Document No. 1800-16
Terra Universal, Inc. • TerraUniversal.com • 800 S. Raymond Ave. • Fullerton, CA 92831 • TEL: (714) 578-6000 • FAX: (714) 578-6020
5
2.
Release the “B” button. The display should indicate “30”, the factory setting in seconds. Press the “A” button
to increase this value. The settable range is from 0 – 255; when the value reaches 255 it will cycle to 0 and
continue climbing. Release when the desired alarm delay appears.
3.
Press and hold the “B” button. The display will show “
done
” to indicate the end of the parameter set up
mode.
4.
Release the “B” button to return to Operation Mode. The display will read the current measured relative
humidity level inside the chamber. The values that have been established will be stored and reloaded each
time the Smart® Desiccator is powered up.
5.0
Desiccator Service and Maintenance
Do not attempt to disassemble any of the modules. Contact Terra for assistance.
WARNING
•
Do not clean acrylic with alcohol or other strong cleaning agents.
•
Do not expose static-dissipative PVC to extreme heat or direct sunlight.
•
A Terra stainless steel shield is required on the bottom of each static-dissipative PVC desiccator
chamber to prevent scratching.
CAUTION
Both acrylic and static-dissipative PVC desiccators should be periodically cleaned with clean, lukewarm water and a
clean nonabrasive cloth. If desired, a mild, non-abrasive detergent may also be used. Use only light pressure when
cleaning.
If the outside of the acrylic is exceptionally dirty or gritty, rinse the surface first by lightly swabbing a saturated cloth
over the surface and allowing surfactants to drain away. Avoid rubbing dirt or grit into the surface. Turn the cloth often
and replace with a clean cloth frequently. Dry the acrylic by blotting gently with a clean, dry cloth.
If you clean the inside of the desiccator with water, you should dry the inside surface thoroughly and then purge the
cabinet with nitrogen for several hours before reintroducing moisture-sensitive materials.
The desiccator is rated for operation in an environment with temperatures between 32°F (0°C) and 104°F (40°C) and
a relative humidity of up to 92%.
Special Care of Static-Dissipative PVC Plating
Although static-dissipative PVC has greater tensile strength the acrylic, it is not as rigid, and so it tends to bow if not
supported adequately. For this reason, you should not stack static-dissipative PVC desiccators or place heavy objects
on top of them.
These desiccators should also be kept away from temperature extremes; avoid prolonged exposure to temperatures
over 80 degrees Fahrenheit. Always avoid scratching the surfaces.
Stainless Steel Desiccators
Stainless steel should always be cleaned with alcohol (or similar cleaning agent) and a damp cloth.
