Step #3:
Align bottom pre-drilled holes to the pilot holes in the bench end (Part B).
After the holes are properly aligned, fasten with (1) One #12 x 3" Flat
Head Phillips Screw per hole.
Note: Be sure to tighten screws completely after this step.
Step #4:
Place a Mounting Plate (Part G) with the countersink's facing up on each
bench end (Part B). Being sure to align the pre-drilled holes to the pilot
holes in the bench end. Use (1) One #12 x 2" Flat Head Phillips Screw
per hole to fasten.
FS-TB6HA-CAP-02
#12 x 3" Flat Head
Phillips Screw
#12 x 2" Flat Head
Phillips Screw
Summary of Contents for FP-TB6HA-CU-02
Page 10: ...FS TB6HA CAP 02 ...
