Fig #1:
In order to make the assembly of this
Traditional ADA Bench easier while going
through the assembly process the board
positions are numbered and will be referenced
in later steps.
Step #1:
Stand (1) One bench end (Part B) upright and place (1) One bench board
(Part A) on position 1 being sure to align the pre-drilled holes to the pilot
holes in the bench end. After the holes are properly aligned, fasten with
(1) One #12 x 3" Flat Head Phillips Screw in the top pre-drilled hole.
Note: Do not tighten screw completely. This will be done in a later step.
FS-TB6HA-CAP-02
#12 x 3" Flat Head
Phillips Screw
1
2
3
4
5
Summary of Contents for FP-TB6HA-CU-02
Page 10: ...FS TB6HA CAP 02 ...
