OPERATION
The heater have a “pull switch” to select the heater's power with an indicator that shows the selection.
The heater is switched on by the pull switch (5). The slight vibration noticeable when the
appliance is switched on will stop after a few seconds.
- Position 0: Stop
- Position 1: 650W (low power)
- Position 2: 1300W (medium power)
- Position 3: 2000W (high power)
The selection changes each time you pull the cord. There is also a safety switch that turns off the radiant
part if the heater tips over. The heating part can be oriented and positioned at the most convenient height:
the height (max = 2,15 m) is adjusted by raising or lowering the telescoping tube and the infrared radiation
and heat is oriented by tilting the heating part (angle = 45° max).
Before each use, make sure the device is in good condition and that the electric cord is not damaged (if in
doubt, contact professionally qualified personnel). Before plugging the cord into the socket, make sure the
switch is off and that the heating part is oriented conveniently.
Then proceed as follows:
1) Plug it in
2) Select the power
3) To turn the heater off, pull the cord of the “pull switch” until you see “0” on the indicator,push the
button to the “0” position and plug out from the current socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods.
CLEANING AND MAINTENENCE
Before cleaning the appliance, switch it off, remove the plug from the current socket and leave it until
getting cool.
Protect the radiant part from dust to preserve its reflectivity.
To clean the base, use a slightly damp, soft cloth; do not use scouring pads or abrasive products.
To clean the radiant part, use a slightly damp, soft cloth; do not use metal scouring pads or abrasive
products, water or other liquids; do not immerse in water or other liquids.
When not being used, cover it and put it in a dry place; it is a good idea to put it back in its original
packaging to protect it from dust and humidity.
A special tool is required to replace the electrical cord and resistance: contact an authorized service center,
also for any repairs.
