19
regarding positioning and switch on.
To use the fan only function:
Turn the rotary switch to “X”. The fan will blow out air at room temperature.
If the fan does not operate, the ambient room temperature is cooler than the
built-in thermostat
”off” level
. Turn the thermostat dial gradually clockwise and the
fan will start blowing.
To use the machine for heating:
Turn the rotary switch to “I” for low heat and “II” for full heat
Set the level of heat by turning the thermostat dial gradually clockwise for the
lowest heat and fully clockwise for maximum.
The thermostat will turn the machine off when the selected room heating is
achieved, and when the temperature drops it will turn on again automatically.
For maximum heat output use “II” with the t
hermostat turned fully clockwise.
To distribute heat evenly around a room, switch on the oscillation function.
SAFETY PROTECTION
The thermostat will turn the machine off if it overheats.
Overheating can be caused by obstruction to the air intakes on the back of the
machine or the grill on the front. If this occurs please disconnect the machine or
the and allow it to cool for 30 minutes. Remove any obstruction and turn the
machine back on.
If the problem persists you should have the machine checked by a suitable
qualified electrician.
If the heater ceases to function, the most likely cause is that a no-self-resetting
thetmal cut-out operates which could be reset by disconnection of the supply ,
mains. If there is still no function please follow the repair advice above.
CLEANING AND MAINTENANCE
There are no parts inside the machine that require your attention or servicing .
Do not try to open the outer case. By doing so you could damage the motor and
heating element and invalidate the warranty. If you have a problem with the
heater, or if the power cord gets damaged in any way , you must take the unit to
a suitably qualified engineer or electrical repair center.
