Put the appliance on a stable and flat surface for no risk of falling down.
(FIGURE 1)
OPERATION INSTRUCTION
Turn the thermostat switch to the minimal value, at
the same time turn the heat select switch to the “O”
position
(See FIGURE 1)
.
Plug in the appliance, and turn the thermostat switch to the maximum position. Then turn the heat select
switch to choose air or warm air and the temperature of warm air as below. While working the indicator light
will be ON
(See FIGURE 1)
.
Turn the heat select switch to the left of
“I”
position,the heater blows warm air, working at 1000W
(SeeFIGURE1)
.
Turn the heat select switch to the left of
“II”
position, the heater blows warm air, working at 2000W
(See
FIGURE1)
.
Turn the heat select switch to “O” position, the heater stops working, the indicator light will be off
(See FIGURE
1)
.
Adjust the thermostat switch to suitable position for desired temperature setting.
When you feel the room temperature comfortable, turn the thermostat switch anti-clockwise slowly to the
minimal position until the appliance stops working.
Then the thermostat switch will keep the room temperature at the desired temperature automatically.
OSCILLATION FUNCTION:
Turn the heat select switch to the right of
“I”
position where there is the symbol of oscillation with two arrows,
the heater blows warm air, working at 1100W;
And at the same time open the oscillation function
Turn the heat select switch to the right of
“II”
position, the heater blows warm air, working at 2000W; and at
the same time open the oscillation function
PROTECTIONS
This heater is protected with an overheat protection that switches off the appliance automatically in case of
overheat, e.g. due to the total or partial obstruction of the grids. In this case ,unplug the appliance ,wait about
10-15 minutes for it to cool and remove the object that is obstructing the grids. Then switch it back on as
described above .The appliance should operate normally. Should the problem persist ,please contact the nearest
customer service.
TIP OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically when the heater falls over,
or is at an excessive angle from the horizontal. This helps prevent accidents, and the heater will resume operation
when it is put back upright.
