BATTERIES PRECAUTIONS
1.
If the appliance is not used for a long time, please remove batteries from remote controller.
2.
To remove batteries open the cover on the back side of the remote controller. Only use
batteries and check correct battery polarity.
3.
Lithium batteries are recommended for a longer remote controller operation.
4.
Please remove batteries if remote controller won’t be used for a long period or if batteries get
hot during operation.
5.
Batteries must be correctly installed inside the proper compartment on backside of the remote
controller
6.
When batteries need to be replaced because they’re exhausted or damaged, Dispose of batteries
according to national regulations written below.
7.
In case of loss of battery fluid, remove all batteries, preventing fluid leaking from coming into
contact with skin or clothes.
8.
If the battery fluid comes into contact with skin or clothes, wash the skin with water
immediately. Before inserting new batteries thoroughly clean the battery compartment with a
cloth or paper towel and follow the manufacturer's recommendations for cleaning the battery.
9.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. Use and replace only
with battery of the same size and type.
10.
Improper use of the batteries may cause leakage, overheating or explosion. Fluid is corrosive and
may be toxic, can cause skin burns and hurt eyes and is harmful to ingest.
11.
To reduce the risk of injury:
Keep batteries out of the reach of children.
Do not heat, open, puncture, shred or dispose of batteries in fire.
Do not mix old and new batteries or different types (for example, the carbon-zinc and alkaline
batteries).
Do not leave metal objects that can come into contact with the battery terminals and then may
become hot and / or cause burns.
FEATURES
1.
High quality plastic shell and long using life.
2.
PTC ceramic heater elements, high efficiency heating, quickly heating, noiseless, odor-free, non-polluting, no
flame and will not killing the oxygen.
3.
Two level heat setting, you can arrange the temperature as your preference.
4.
There is temperature fuse for fear of overheating and motor overheat protection. Automatically turn off when the
wind outlet is blocked and turn on again when the sundries are cleared away.
5.
Natural/hot wind for selection. You could close the heat element in summer; the heater could blow cool wind.
6.
Safety thermostat. Overheat protection.
INSTALLATION
Drill two holes in wall and have a distance of above 2.0m from the ground, the diameter of the hole just contained the
expansion bolt, which the diameter is 6mm. After tucked the expansion bolt, fixed pothook on the expansion bolt with
screw. Make sure pothook should be inserted the bottom. See the drawing as following for a better understanding. (see
