The electrical connection of the product is “Y” type and local instructions should be
exactly observed.
If the supply cord is damaged,it must be replaced by the manufacturer or its service
agent or similary qualified persons in order to avoid a hazard
The appliance is designed for using with plug or fixed connection to the mains. There is to install
an all pole disconnector inside the supply circuit with a contact openning of at least 3mm ( rated
A, delay functioning type ).
Wiring of the appliance must be performed by the Authorized Service.
[PP
supply cable
must be used.
Please be sure that the voltage and electrical connection conditions of your house
conform to your appliance before installing the appliance; and connect your built-in
cooker to the power supply with the cord at the rear part of the appliance. Your house
and electric inlet must be earthed and conform to the CE directives.
In case that an installation violating the instructions above is performed, the
manufacturer company shall take no responsibility.
The heat protection class is “Y”.
Warning
:
The cables should not be allowed to contact the sections that would
cause the heat to increase on the same.
All of the maintenance and repair works should be undertaken by the authorised
technical service personnel or the personnel who had been authorised by the technical
service.
Warning
:
In all kinds of maintenance works in respect of the product, please
disconnect all of the electric connections.
For a new connection, follow the connection diagrams carefully.
The earth connection should be made to the terminal which is shown with (earth symbol
shall be used) in the terminal box.
Figure 4
