Termikel 13550, User Manual

Page: 19 / 24

● Remove the glass front door by unscrewing the fixings using
a screwdriver, remove the inside glass, clean and rinse it.
After drying it place the seal properly and re-install the glass
Removing Oven Door for Easy Cleaning
Before cleaning oven door, we advise you to follow steps below to seperate
oven door from oven body :
1- Open the door completely
2- Insert the pin as in figure. Make sure that this is done on both hinges.
3- Push up the locking part of hinge with screwdriver as shown in Figure
below.
4- Lift the door slightly as if closing, then with both hands supporting the
door; pull it away from the oven.
Clean the glass part of oven door with hot water and only a soft cloth
Inserting the Oven Door
1- Hold the door in an open position and push up the locking part with
screwdriver.
2- Place hinges into the hinge holes.
3- Support the oven door and push down the locking part with screwdriver.
4- Remove pins from the hinges. Open and Close the door to make sure
that it has been fitted correctly.
Oven Gasket
Please check this gasket at regular periods. If it requires cleaning, clean it
without using abrasive materials.
If gasket is damaged, immediately contact with closest authorised servicel.
Do not use oven till gasket repaired or replaced.
Changing Oven Lamp
1. Pull the plug out of socket.
2. Turn the lamp fixing glass counter-clockwise direction to seperate it.
3. To seperate lamp from body turn it to counter-clockwise direction.
4. Fix new lamp that you gain from authorised service in place of old lamp.
5. Ensure the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.
Shelling Out Inner Glass of Door
Removal oven door for easy cleaning
Before cleaning the oven door, we advise you to follow below steps to
seperate oven door from the oven body:
1. Open the door completely. Dismount the locking part on the hinge by
lifting with screwdriver.
2. Push the locking part in the direction of the glass door to the hinge body.
3. Open the glass door to the back slightly and insert the locking part
to it’s place on hinge. Make sure that this is done on both for left and
right hinges.
4. Lift the door slightly and pull the door with your two hands to
seperate from the oven.
Inserting the oven door
After cleaning, for inserting oven door to oven body it is recommended
to apply below steps:
1. Hold the door in open position and insert the hinge to hinge counter part.
2. Open the glass door to the back slightly for getting the locking part
and then push ahead and lock with screwdriver.
3. Open and close the door to make sure that it has been fitted
correctly.
- 1 -