User Manual — Electric heating elements of the SKT series
57
FIL-PILOTE INTERFACE
Selected versions of SKT-3 are equipped with a FIL PILOTE inter
-
face which enables remote heating control through an external
controller which conforms to FIL PILOTE standards. SKT-3 reacts
to all the 6 standard commands:
TROUBLESHOOTING
FP-COMFORT
Heating in accordance with current
setting
FP-ECO
Reduction of setting by 3°C (or 3 levels
in heat output regulation mode)
FP-AF
No heating, anti-freeze function is active
(AF code shows on the display panel)
FP-STOP
Heating mode and anti-freeze functions
are both off (OF code shows on the
display panel)
3 s
300 s
7 s
300 s
FP-ECO1
FP-ECO2
Reduction of setting by 1°C (or 1 level in
heat output regulation mode)
Reduction of setting by 2°C (or 2 levels
in heat output regulation mode)
Signal
FP Command
Reaction of the Controller
It is also possible to use the DRYER mode while the device reacts to
the FP commands – DRYER mode is superior, therefore the device
will work according to the DRYER'S parameters. It will return to
fulfilling FP commands on termination of the DRYER mode (see
– DRYER mode).
Device is connected to
electricity, LCD display
is blank
Connection problem
Check the power lead is
connected. Check if the
controller uptakes
correct voltage.
Device does not heat,
terror code (ie. E9) is
flashing on the display
Temperature sensor
problem
Disconnect the device
completely from
electricity and wait until
the radiator cools down.
Turn it back on again.
Possible incorrect
installation of controller
on the heating element
Check if the controller
has been correctly
installed on the heating
element (controller
casing should hide the
entire head of the
heating element).
Device heats despite
having been turned off
with the button
Possible electronics
damage
Disconnect the device
completely from
electricity and wait until
the radiator cools down.
Turn it back on again.
Problem
Possible cause
Problem solution
If the problem persists, please contact your local Distributor
Summary of Contents for SKT 1
Page 7: ...Mode d emploi Kit r sistance lectrique 7 Zone 1 Zone 2...
Page 39: ...User Manual Electric heating elements of the SKT series 39 Zone 1 Zone 2...
Page 64: ...64 180 92 Radiateur lectrique Electric only Radiator A 1 2 3 Installation...
Page 65: ...65 4 7 5 8 6 9 5 5 0 5 h MAX 230 V 50 Hz 5 1 2 1 2 MAX 60 5 0 1 5 mm...
