INSTALLATION
I
NSTALLING
T
HE
TRK-SR1 (
CONTINUED
)
9. If the XM system is not already installed, temporarily connect power and
ground to the system. Temporarily connect the ThruGlass Coupler to your
XM receiver, as directed by the receiver’s manufacturer (see Figure 13 below).
Set the ThruGlass Coupler aside in a safe area.
Figure 13. Wiring diagram shows antenna connections to an XM receiver.
NOTE: Do not route the antenna cable at this time.
For the Sony DRN-XM01
Digital Audio Receiver
, use a small jeweler’s screwdriver to remove the plastic
case and inserts from each FAKRA-type SMB connector (see Figure 14 ).
Figure 14. Removing the plastic case and inserts
.
10. At the corresponding interior site, use the remaining Cleaning Towelette to
clean the installation area on the vehicle’s inside window.
11. Peel off the protective backing from each of the four adhesive dots on the
second Installation Template. Lightly position it on the inside window so that
its registration marks align with those on the outside template, as shown in
Figure 15 on the next page.
10
Installation
From TRK-SR1
ThruGlass Coupler
Green
(Terrestrial)
Curry
(Satellite)
Antenna
1 2
XM Receiver (Tuner)
Step 1
Step 2
FAKRA-type SMB Connector
(Side View)
Case
Jeweler’s
Screwdriver
Lift Tab
Case
Insert
Insert
TRK-SR1 Install Guide 8/29/01 9:06 AM Page 10
