Terex Genie GTH1056, Service And Repair Manual

Page: 58 / 155

Service and Repair Manual April 2018
Hydraulic Pump
48 GTH-1056 Part No. 1287211GT
3 Remove the plug and slowly fill the case drain
port of the pump with hydraulic fluid until the
oil level is even with the bottom of the hole.
Install the plug and torque to 40 ft-lbs / 54 Nm.
4 Start the engine, allow the engine to run at low
idle for 15 seconds then shut off the engine.
Wait 15 seconds, then start the engine again.
Allow the engine to run at low idle for
15 seconds and then shut off the engine.
5 Check for hydraulic leaks and clean up any oil
that may have spilled.
How to Adj ust the Functi on Pum p Standby Pr essure
How to Adjust the Function Pump
Standby Pressure
1 Connect a 0 to 1000 psi / 0 to 100 bar
pressure gauge to test port 'TP' on the primary
function manifold. Refer to Primary Function
Manifold Components.
2 Start the engine and allow the engine to run at
low idle.
3 Observe the pressure reading on the pressure
gauge.
Result: The pressure gauge reads 450 ±25 psi
/ 31 ±1.7 bar. The pump is functioning
correctly. Proceed to step 6.
Result: The pressure gauge fails to read 450
±25 psi / 31 ±1.7 bar. The pressure setting
needs to be adjusted. Proceed to step 4.