Terex Genie GTH1056, Service And Repair Manual

Page: 29 / 155

April 2018 Service and Repair Manual
Boom Components
Part No. 1287211GT GTH-1056 19
How to R emove the Cable Bridge Assembly
How to Remove the Cable Bridge
Assembly
Inside the four-section boom, a cable bridge is
used to route hydraulic lines through the boom
assembly to the fork level cylinder and auxiliary
connections (if equipped).
1 Remove the inspection cover at the pivot end
of the boom.
2 Working at the pivot end of the boom, remove
the fasteners securing the cable bridge rear
mount bracket to the boom assembly.
Remove the bracket from the boom.
1 cable bridge mount bracket
2 cable track mount bracket
3 cable bridge slider
3 Working at the pivot end of the boom, tag,
disconnect and plug the hydraulic hoses at the
hard lines of the cable bridge. Cap the fittings.
4 Working at the pivot end of the boom, remove
the fasteners securing the hose roller
assembly to boom tube number 1. Remove
the hose roller assembly from the boom.
5 Working at the fork end of the boom, remove
the fasteners securing the cable track mount
bracket to boom tube number 3.
6 Working at the fork end of the boom, remove
the fasteners securing the cable bridge slider
to the cable bridge. Remove the slider from
the boom.
Note: Pay attention to how the hoses are routed
before removing the slider from the boom.
Note: During reassembly, it may be helpful to use
tape to secure the bolts to the cable bridge when
installing the cable bridge slider.
7 Working at the fork end of the boom, securely
attach the loose end of the cable track to the
cable bridge using a cable tie or similar device.
8 Working at the pivot end of the boom, carefully
remove the cable bridge from the boom.