Terex Genie GS-2669 BE, Service Manual

Page: 18 / 205

Service Manual May 2015
Specifications
2 GS-2669 BE • GS-3369 BE • GS-4069 BE Part No. 1257106
Performance Specifications
Drive speed, maximum
Platform stowed
Forward direction
4.5 mph
7.2 km/h
40 ft / 6.1 sec
12.2 m / 6.1 sec
Platform stowed
Reverse direction
3.0 mph
1.8 km/h
40 ft / 9.1 sec
12.2 m / 9.1 sec
Platform raised 0.3 mph
0.5 km/h
40 ft / 91 sec
12.2 m / 91 sec
Braking distance, maximum
High range on paved surface less than 3 ft
less than 0.9 m
Gradeability See Operator's Manual
Function speed, maximum from platform controls
(with maximum rated load in platform)
GS-2669 BE
Platform up
Platform down
29 to 39 seconds
GS-3369 BE
Platform up
Platform down
29 to 39 seconds
GS-4069 BE
Platform up
Platform down
34 to 44seconds
Outrigger leveling, maximum
Front
Back
Side to side
5.3°
4.2°
11.7°
Hydraulic Specifications
Hydraulic Fluid Specifications
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Cleanliness level,
minimum
ISO 15/13
Water content,
maximum
250 ppm
Recommended Hydraulic Fluid
Hydraulic oil type Chevron Rando HD Premium
Viscosity grade 32
Viscosity index 200
Optional Hydraulic Fluids
Mineral based Shell Tellus S2 V 32
Shell Tellus S2 V 46
Chevron 5606A
Biodegradable Petro Canada Environ MV 46
Fire resistant UCON Hydrolube HP-5046
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie
Product Support before use.
Optional fluids may not have
the same hydraulic lifespan and
may result in component
damage.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond it's
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.