Terasic VEEK-MT-SoCKit, User Manual

Page: 22 / 34

VEEK-MT-SoCKit User Manual
www.terasic.com
March 17, 2014
20

Demonstration Setup

Make sure both Quartus II and Nios II are installed on the host PC

Power on the SoCKit board

Connect a USB cable to the USB-Blaster port on the SoCKit board and install the USB-Blaster
II driver if necessary.

Configure the FPGA by executing the demo batch file “test.bat” from the directory
“SoCKit_Painter\demo_batch” (Note*)

After the programming is downloaded and executed successfully, you will see a painter GUI
displayed on the LCD.
Figure 4-2 shows the GUI of the Painter demo .

The GUI is classified into three areas: Palette, Canvas, and Gesture. Users can select pen color
from the color palette and start painting in the Canvas area. If a gesture is detected, the
associated gesture symbol is shown in the gesture area. Click the “Clear” button to To clean up
the content in the Canvas area.

Figure 4-3 shows the photo when users paint in the canvas area. Figure 4-4 shows the photo
when counter-clockwise rotation gesture is detected. Figure 4-5 shows the photo when zoom-in
gesture is detected.
Figure 4-2 GUI of the Painter demo