1-4
Caution
Check that the delivered items are exactly what you
ordered.
The use of a wrong product may cause an injury or failure.
Do not place any combustibles around the product.
Otherwise, it may lead to a fire.
Do not place any obstacles around the product that
may hinder ventilation.
Otherwise, it may lead to a fire.
Do not touch the impeller, tie bolt, or strainer of the
pump with bare hands.
Otherwise, it may lead to an injury or damage.
Do not run the pump at a frequency exceeding 60
Hz.
Otherwise, it may lead to motor burnout or a fire.
Do not use the unit for pumping any fluids beyond
the specified viscosity limit.
Otherwise, it may lead to motor burnout or a fire.
Ensure to install an overcurrent protective device.
The user is required by the technical standards for electrical
facilities to install one. Otherwise, it may damage the product,
thus leading to a fire or failure.
It is also recommended to
install protective devices such as a ground fault interrupter.
Do not touch any terminals or wires when
measuring the insulation resistance.
Otherwise, it may lead to an electric shock.
Do not run the pump with its strainer removed.
Otherwise, it may lead to an injury or damage.
Once you turn off the power, wait until the pump
stops completely. Do not restart the pump until it
does.
Otherwise, the main shaft may be subjected to an excessive
load, which makes the service life of the pump shorter.
Do not touch the impeller after removing the
strainer.
Otherwise, it may lead to an injury.
If you use a solvent for cleaning the product, pay
attention to handling of the solvent as well as the
environment of use.
Otherwise, it may lead to poisoning.
Do not use thinner or benzene for cleaning the
product.
Otherwise, the product may be discolored or its coating may
be peeled off.
Dispose of the product as industrial waste.
When you hoist the product, pay attention to its
center of gravity.
Otherwise, the product may topple over or fall, thus leading to
an injury.
When you lift the product by hand, pay attention to
its weight. Do not allow a single person to lift a
product heavier than 15 kg.
Otherwise, it may put strain on the body, thus leading to an
injury.
Be sure to conduct inspection according to the
Maintenance checklist.
Otherwise, you cannot prevent potential failures, thus leading
to a higher risk of accidents.
Do not put your fingers or foreign objects into
leakage detection hole.
Otherwise, it may lead to an injury or damage.