2-2
2.3 Standard specifications
Applicable
liquid
Quality
Water soluble coolant, liquids of similar viscosity to water
containing additives (anti-rust agents) and the like
Note 1
Temperature
0 to 60°C (No frozen liquid is allowed.)
Allowable kinematic viscosity
40A: 32 mm
2
/s or less 40B: 150 mm
2
/s or less
Installation location
Indoors
Ambient temperature: -20 to 40°C; humidity:85
％
RH or less (no
condensation);
Height above sea level: 1,000 m or less; place not exposed to
direct sunlight; place without any corrosive gas, explosive gas, or
vapor in the atmosphere
Bore diameter[A]
40
Material
Casing
(suction/discharge
/middle/)
FC200
Impeller
FCD450
Main shaft
S45C
Shaft sealing structure
Sealless structure (without mechanical seal)
Motor
Type
Totally-enclosed fan-cooled indoor type
Protection method IP44
Power source
3-phase 50Hz
380V
Thermal class
130
（
B
）
Rating
Continuous (S1)
Number of poles
2P
Noise [dB(A)]
71 *
Reference value at a point 1 m away from the bearing on the
load side at an angle of 45 degrees
Coating color
Munsell N1.5
Note 1 Note that the product cannot be used for water. If the liquid contains hard foreign matters or large
amount of foreign matters (cutting chips), contact TERAL.
2.4 Information indicated on the nameplate
The specifications of the pump are indicated on the nameplate. Upon receiving the pump, check the
nameplate to verify that the delivered product is exactly what you ordered. Be sure to confirm the
model, motor output, frequency, and voltage. If there is anything different from what you ordered,
contact the vendor from which you purchased the product.
Do not remove the nameplate or place any obstacles in front of it. Always keep the nameplate
clearly visible.
*
