Teradici Tera2, Quick Start Manual

Page: 6 / 69

If possible, connect the host PC
’
s front-panel On/Off switch cable to the 2-pin header on the host
card power button cable. If this is not possible, the host PC
’
s front-panel On/Off Switch is disabled.
C
3
English
B
C
A
Host Card
Host PC Motherboard
Front Panel
On/Off
Switch
INSTALLATION STEPS
1. Ensure host PC is turned off and unplug the power cables.
2. Remove the chassis cover and locate an available PCIe slot.
3. Remove the expansion slot cover of the appropriate PCIe slot for the PCoIP host card.
4. Insert PCoIP host card into PCIe slot and secure metal bracket.
WARNING
Always power down and disconnect devices from AC power before handling them. Failure to do this can
result in personal injury or equipment damage. Some circuitry on the host PC can continue to operate even
though the front panel power switch is off.
5. Install PCoIP host card power button cable
This optional connection allows a remote user to reset the host PC (such as when the operating system
is non-responsive).
Connect the white end of the host card power button cable to the power button cable connector on
the host card.
Locate where the host PC front-panel power button cable connects to the motherboard. Disconnect
the host PC’s front-panel On/Off switch cable from the motherboard’s header, and locate the Power
On/Off signal pins. Connect the red wire on the host card power button cable to the positive terminal
of the Power On/Off pin, and the black wire to the negative terminal. The negative terminal is
typically a ground pin.
A
A B
NOTE: motherboard to another. See your
motherboard user manual for details. If you have the connector inversely connected the host PC will not power up.
The location of the Power On/Off switch pins is different from one