TCW181B-CM_R1
Page 3
6.
Powering
TCW181B-CM
is designed to be supplied by adapter SYS1421-0612-W2E or similar, intended
for use in the conditions of overvoltage category II, and priorly assessed for compliance with safety
requirements. The power supply equipment shall be resistant to short circuit and overload in
secondary circuit.
When in use do not position the equipment so that it is difficult to disconnect the device from
the power supply.
7.
Environment information
This equipment is intended for use in a Pollution Degree 2 environment, at altitudes up to
2000 meters.
When the controller is a part of a system, the other elements of the system shall comply with
the EMC requirements and shall be intended for use in the same ambient conditions.
8.
Safety
This device must not be used for medical, life saving purposes or for any purpose where its
failure could cause serious injury or the loss of life.
To reduce the risk of fire, only flexible stranded wire, with cross section 0.5mm² or larger for
wiring of digital and analog inputs and relay output of the device should be used.
To avoid electric shock and fire hazard, do not expose this product to liquids, rain, or
moisture. Objects filled with liquids, such as vases, should not be placed on this device.
There is a risk of overheating (damage) of controller, if recommended free spaces to adjacent
devices are not ensured. Joint part with external component shall have space for
attachment/removal of the cable after installation.
Teracom does not guarantee successful operation of the product if the product was used
under conditions deviating from the product specifications.
To ensure that the device works correctly follow the steps below:
ensure that the devices are installed correctly, refer this user manual;
log in to the devices via browser program;
make proper set up;
set up the digital inputs to work in “dry contact” mode;
short the “DI” and “GND”;
Switch on “Monitoring page” of WEB interface – proper value for digital input should be
displayed in the same time
Sts
led should flashes;
When you push the button “All On”, all relays should be activated and all relay’s status
LED’s should be constantly shine.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
In no event will Teracom Ltd. be responsible or liable for indirect or consequential damages
resulting from the use or application of this equipment.
9.
Maintenance
Upon completion of any service or repairs to the device or once per year, safety check must
be perform to determine that this product is in proper operating condition.
Clean the device only with dry cloth. Do not use a liquid cleaner or an aerosol cleaner. Do not
use a magnetic/static cleaning device (dust remover) or any kind of abrasive materials to clean the
device.
