Favorite mode (Fig. 3):
The Favorites mode allows up to four favorites to be called up quickly and selectively.
By holding down the ">II" key and then pressing the "CH1" keys for
"Favorit 1" to "CH4" for "Favorit 4" the device plays the selected track in a continuous loop.
Use the ">>" and "<<" buttons to switch between the four favourite tracks.
Cable test function:
Call up the menu (Fig. 2).
Connect one end of the cable to be tested to the appropriate speaker output.
on your TQX (CA-COM/NL8, NL4). Connect the other end to the appropriate measuring adapter.
Now the measurement can be started by pressing the "CH1" key. The instrument runs through
automatically tests all connected channels. In the display, these are displayed by means of
of a matrix. During this process the keys "CH1" to "CH4" light up.
one after the other.
As soon as all four channel keys light up continuously, the measurement is finished. Now the
Test result based on corresponding markings in the matrix (GREEN = intact / RED = defective)
can be read.
Notice:
Perform the cable measurement only with the enclosed measuring adapter. If a loudspeaker is
connected to the outputs during cable measurement, the cable will be detected as faulty and
the loudspeaker could be damaged.
If the device is set to cable test mode by simultaneously pressing the ">>" & "<<" keys, an XLR
cable can also be checked "acoustically" for its function (a signal output at the XLR output is fed
back into the XLR input via the cable to be tested and can be listened to via the internal
loudspeaker or the headphone output).
Press the "Mute" button to exit the cable measurement function.