ENG
Binar-5B/5D-Compact
Correct
Figure 7.9 - Cutting
Attention!
The fuel pipe and fuel pump shall be protected from heating. It is
prohibited to install them close to the exhaust pipe or on the engine.
7.2.8. Assembling of the pre-heater electrical harness.
The pre-heater wiring harness shall be connected as shown the pre-heater electric
circuit in figure 4.1.
While assembling note that heating, deformation or displacement of harness during
operation of the vehicle is unacceptable. The wiring harness shall be fixed with plastic
clamps to the components of the vehicle.
Attention! Assembling shall be performed with the safety devices dismantled.
7.2.9. Installation of the control panel.
Control panel is installed in the cabin on the dashboard or any other comfortable for
the driver place. The control panel is fixed by adhesive tape. Degrease the surface before
installation of the panel, remove protective film from the tape.
8
Post-installation checkout.
8.1 On completion of the assembling, the following shall be guaranteed:
- leak profess of the fluid system;
- leak profess of the fuel pipes;
- security of the pre-heater electric contacts attachment
8.2 Open the heater control valve to full. Remove air blocks from the fluid system
of the vehicle following instructions of the vehicle manufacturer. Put vehicle heater fan
switch in position of min rotation.
Incorrect
the fuel pipe before installation
32
