3.4. Setting of parts with direct access.
3.4.1. Set clutch plug 23 into frame 4 and fix it by retaining wire 94 and roll pin 73 (see
p. 2.1.10).
3.4.2. Set cutter blade 20 in the opening of side cover 5 and die holder 15 and fix it by
screw 46 (see p. 2.1.9).
3.4.5. Set bush 43 with plates 44 (if necessary) into frame 4 and fix them by screws 74
(see p. 2.1.8).
3.4.6. Screw the screw 39 into handle 3 (see p. 2.1.7).
3.4.7. Screw until stop screw 73 (see p. 2.1.6).
3.4.8. Screw front and rear guides 67 (see p. 2.1.5).
3.4.9. Screw guide 52 (see p. 2.1.4).
3.4.10. Set guide 51 in necessary position and fix it by screws 76 (see p. 2.1.3).
3.4.11. Screw knobs 33 into handles 1 and 2 (see p. 2.1.2).
3.4.12. Set adjustment plate 32 on excentric shaft 13 so, that the label on another side of
excentric shaft indicate «9 hours». Fix adjustment plate in such position by screw 76
with washer 82 (see p. 2.1.1).
Make regulation of assembled tool, using operating instructions.
23
