TensCare itouch easy, Instructions For Use Manual

Page: 20 / 22

36
35
EMC PRECAUTIONS
Use special precautions regarding EMC according to the information
provided below.
Other portable and mobile RF communications equipment can affect performance.
Do not use when adjacent to or stacked with other electrical equipment. Use of
leads or probes other than those listed in section 18 may affect EMC performance.
The Itouch Plus is intended for use in the electromagnetic environment specified
below. The customer or the user of the Itouch Plus should assure that it is used in
such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment guidance
Electrostatic ±6 kV contact ±6 kV contact Floors should be wood, concrete or
discharge (ESD) ±8 kV air ±8 kV air ceramic tile. If floors are covered with
IEC 61000-4-2 synthetic material, the relative
humidity should be at least 30 %.
Electrical fast ±2 kV for power supply Not applicable Not applicable
transient/burst lines
IEC 61000-4-4 ±1 kV for Input/output lines
Surge ±1 kV differential mode Not applicable Not applicable
IEC 61000-4-5 ±2 kV common mode
Voltage dips, short <5 % UT (>95 % dip in Not applicable Not applicable
interruptions and UT) for 0,5 cycle
voltage variations 40 % UT(60 % dip in
on power supply UT ) for 5 cycles
input lines 70 %UT (30 % dip in
IEC 61000-4-11 UT )for 25 cycles
<5 % UT (>95 % dip
in UT ) For 5s
Power frequency 3 A/m Not applicable Not applicable
(50/60 Hz) magnetic
field IEC 61000-4-8
NOTE UT is the a.c. mains voltage prior to application of the test level
Guidance and manufacturer’s declaration - electromagnetic emissions
The itouch Sure is intended for use in the electromagnetic environment specified below.
The customer or the user of the itouch sure should assure that it is used in such an environment.
Emissions test Compliance Electromagnatic environment - guidance
RF emissions Group 1 The model itouch uses RF energy only for its
CISPR 11
internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
nearby electronic equipment.
RF emissions Class B
The model itouch is suitable for used in domestic
CISPR 11 establishment and in establishment directly connected
to Harmonic emissions a low voltage power supply
Harmonic emissions Not applicable
network which supplies buildings used for domestic
IEC61000-3-2 purposes.
Voltage fluctuations/ Not applicable
flicker emissions
IEC 61000-3-3