18
17
10. CONNECTING MONO LEADWIRE
11. POSITIONING OF ELECTRODE PADS
The following body maps in this instruction
booklet will show you where to place the
electrode pads for a range of common
complaints, dependent on your symptoms.
For symptoms not illustrated, apply the
pads around/near to the source of the
pain or seek advice from your doctor
or physiotherapist.
The electrode pads must always be used in
pairs, so that the signal can flow in a circuit.
NOTE: Always check unit is OFF before
attaching or removing pads.
Insert the Mono leadwire plug into the base
of the unit.
Please note that it has been
designed to only insert one way.
Attaching the electrode pads to
Mono Lead wire
At the other end of the Mono Lead wire,
the lead wire splits into four pin ends,
2 white and 2 black. Push the pin ends into
the pigtail ends of the electrode pads.
The mono lead wire can be split as required
and adjust the toggle as necessary.
Mono Lead wire colour coding
L-IT … Mono Lead wire (dual channel), as
supplied with the unit, has FOUR wires for
use with four pads. Two of the wires are
white and the other two are black. Channel
1controls the output to the white wires and
Channel 2 to the black wires.
It is also possible to use L-IT Mono Lead wire (dual channel) with
only two pads using only the white lead wires. In which case the
black lead wires, as they are not in use, can safely be put to the
side - There is no risk from the exposed pins.
L-IT-1 Mono Lead wire (single channel) can be purchased as an
accessory. This lead is for those who only wish to use two pads
through Channel 1.
Summary of Contents for itouch easy
Page 22: ...39 NOTES...
