MAINTENANCE
93
Centurion 331020 (11--03)
14. Locate and mark both the front and rear
skirt lift shaft bearing mounts (I), and
remove the bolts that hold the bearing and
mount to the center shroud.
15.Remove the center skirt shaft deflector
assembly.
16.Cut and or scrape off all of the RTV or
silicone sealant that surrounds the seams of
the center shroud where it attaches to the
right and left shrouds.
17.Remove all of the hardware that attaches to
the center shroud to the right and left
shrouds.
18.Remove the center panel.
NOTE: This may require two people to maneuver
the shroud out of the way to access the
transmission.
19.At this time, the transmission is now ready
for service.
NOTE: The recommended transmission
fluid and filter change intervals are
listed in the transmission and/or service
section of the CD/manual.
20.When service is complete, run engine and
inspect the machine for any leaks before
reassembling. Install center shroud and
hardware, leaving the hardware loose until
the entire assembly is installed. Tighten and
re--seal the seams with clear silicone
sealant. Use reverse order for reassembly.
I