SEAT SWITCH KIT
INSTALLATION INSTRUCTIONS --
Continued
KIT NO. 9009316
EN
9009329 Rev. 02 (01--12)
Tennant Company
www.tennantco.com
5. Route and connect the purple wire harness,
supplied with kit, to new seat switch as shown.
Secure wire with cable--tie.
Cable--Tie
Purple
Wire
Harness
6
Route the opposite end of the purple wire harness
down through the battery compartment hole,
under the machine frame, along the main wire
harness and up through the floorboard hole as
shown. Secure the wire to the main machine
harness under the machine with cable--ties.
Purple Wire
Harness
7. Connect the purple wire harness to Circuit
Breaker #1 and secure wire with cable--tie.
Cable--
Tie
CB 1
Existing Purple Wire #7
New Seat Switch Wire
Green #5B
8. Cut the Black [#13AB] and Green [#15] wires
going to the seat switch wire connector. Strip
wires back approximately 9mm. You may need to
remove battery to access connector wires.
Seat Switch Wire
Connector
Strip
Wires
Cut
9. Connect the resistor wire assembly, supplied with
kit, to the cut wires as shown.
Resistor
Wire
Assembly
10. Replace battery and reconnect the battery cable
connector.
11. Disconnect the seat switch wire connector and
press the propel pedal without an operator in the
seat to insure machine does not propel. Reconnect
the seat switch connector after testing.
12. Lastly, test the seat switch function with and
without an operator in the seat to insure proper
operation.
Home
Summary of Contents for 9009316
Page 2: ...Home ...
