OPERATION
EN
9
Tennant T1 Li (09--10)
3. Press the main power switch to the on ( I ) position
(Figure 10).
FIG. 10
4. Press the vacuum switch to the on (I) position
(Figure 11).
FIG. 11
5. To begin scrubbing, pull the start triggers and push
or pull the machine in either direction (Figure 12).
FIG. 12
6. To stop scrubbing, release the triggers and
continue to move the machine to pick up all
solution.
7. When scrubbing, view the water pickup from the
recovery window (Figure 13). When the water
pickup stops, stop scrubbing and empty the
recovery tank.
ATTENTION: When refilling solution tank always
empty the recovery tank.
NOTE:
To protect the vacuum motor from potential
damage, the cover is equipped with a vacuum shut--off
float that will stop water pickup when the recovery tank
becomes full (Figure 14). A sudden change in vacuum
motor sound will occur when this happens.
FIG. 13
FIG. 14
ATTENTION: Check for excessive foam in the
recovery tank. Foam may not activate the shut--off
float. Foam intake may damage machine and void
the manufacturer’s warranty.
FOR SAFETY: When operating machine, if foam or
liquid begins to leak from machine, immediately
shut off machine.
8. For heavily soiled areas, use the double scrub
method. First scrub the soiled area with the
vacuum switch turned off then scrub the area a
second time with vacuum switch turned on
(Figure 15).
FOR SAFETY: Before operating machine, place wet
floor signs as needed.
FIG. 15
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
