Page 3 of 3
KIT NO. 9002378
INSTALLATION INSTRUCTIONS -- Continued
9002379 Rev. 00 (02--06)
Tennant Company
Customer Service: (800) 553--8033 or (763) 513--2850
14. If a star washer is not already installed, add
one from the kit, beneath the clamp, on this
seat support stud (Figure 10).
Fig. 10
CHECK CONTINUITY:
NOTE:
For the tests below you may need to
scrape a bit of paint off to get down to the
metal for points 2 & 3. This should be done
sparingly and in an inconspicuous location.
1. To check for continuity between the
steering tower and the control board
housing, use either a continuity tester or
VOM set to ohms between points 1 & 2.
The continuity meter should beep or light
up, the VOM should read less than about
10 ohms (Figure 11).
2
1
Fig. 11
2. To check for continuity between the seat
pan and the control board use the same
procedure across points 2 & 3. Note, if you
have continuity between 1 & 2 you can test
across either of points 1 or 2 to point 3
(1--to--3 or 2--to--3).
If you don’t have continuity, make sure that
the star washers broke through the painted
surfaces (Figure 12).
3
2
Fig. 12
