Tennant 6400IC, Service Manual

Page: 13 / 424

GENERAL INFORMATION
1--11 6400IC MM433 (9--96)
Interval Key Description Procedure
Lubricant/
Fluid
No. of
Service
Points
100 Hours 9 Hopper dust filter Check for damage, clean or
replace
-- 1
14 Hydraulic fluid reservoir Check fluid level HYDO 1
6 Tires Check for damage -- 3
Check pressure -- 1
12 Main brush and hopper
seals
Check for damage or wear -- 8
3 Engine Change oil and filter element EO 1
Clean or replace spark plugs -- 2
Clean or replace air filter element -- 1
Clean cooling fins -- 1
4 Battery
H
Check electrolyte DW 1
200 Hours 1 Rear wheel support
bearings
Lubricate SPL 2
13 Brakes Check and adjust travel -- 1
2 Steering cylinder Lubricate SPL 1
3 Vacuum fan belt Check tension and wear -- 1
11 Side brush guard Rotate 90
_
-- 1
7 Hopper lift arm pivots Lubricate SPL 2
11 Side brush pivot Check adjustment -- 1
400 Hours 6 Front wheel bearings Check for seal damage -- 2
800 Hours 14 Hydraulic fluid reservoir Replace filler cap -- 1 y
Replace suction strainer -- 1
Change hydraulic fluid HYDO 1
15 Hydraulic fluid filter
H
Change filter element -- 1
-- Hydraulic hoses Check for wear and damage -- All
2 Propelling motor
H
Torque shaft nut -- 1
2 Rear wheel
H
Torque wheel nuts -- 1
3 Engine Replace fuel filter -- 1
4 Battery
H
Clean and tighten battery cable
connections
-- 1
LUBRICANT/FLUID
DW Distilled water . . . .
EO Engine oil, SAE--SG/SH rated . . . .
HYDO Tennant or approved hydraulic fluid .
SPL Special lubricant, Lubriplate EMB grease (TENNANT part no. 01433--1) . . .
NOTE: Also check procedures indicted (
H
) after the first 50 hours of operation.
NOTE: More frequent intervals may be required in extremely dusty conditions.